CAD SchemCAD
MOSFETs de Potência e DrMOSMonolithic Power Systems (MPS)TQFN (5x5mm / 4x5mm)

MP86945AGLT — Datasheet PDF, Pinagem (Pinout), Código SMD, Equivalentes e Placas Doadoras

MPS 60A Intelli-Phase DrMOS Power Stage for High-End Gaming Laptop CPU/GPU Vcore

Fabricante
Monolithic Power Systems (MPS)
Encapsulamento
TQFN (5x5mm / 4x5mm)
Tensão de Entrada (VIN)
4.5V – 22V
Saída / Arquitetura
60A Intelli-Phase DrMOS Stage
Marcação SMD

Tabela de Diagnóstico no Multímetro e Pinagem de Start — MP86945AGLT

Pino # Sinal Função Tensão Esperada / Diagnóstico
VINVINpower_inHigh-voltage input from B+ (CRITICAL: check VIN-to-SW short before powering!)
VCC/PVCCVCC/PVCCpower_in+5V internal gate driver supply
PWMPWMcontrolTri-state PWM input from multiphase controller (Hi-Z = Hi/Lo FETs off)
EN/DISB#EN/FCCMcontrolDriver enable / CCM mode control
BOOTBOOToutputsBootstrap capacitor pin to SW
SWSW/VSWHoutputsPhase switch node to CPU/GPU inductor (low ohm 0.3–15Ω on modern GPU/CPU is NORMAL)

Códigos SMD e Substitutos Compatíveis (Equivalentes)

Códigos de Marcação SMD
Equivalentes Pino a Pino

Confira sempre o encapsulamento QFN/SOIC e a polaridade de ACOK / EN no esquema antes da substituição.

Placas-Mãe Doadoras (Sucata) com MP86945AGLT

Pesquise MP86945AGLT nos esquemas elétricos e BoardViews do SchemCAD.

🔎 MP86945AGLT →

Perguntas Frequentes de Reparo — MP86945AGLT

What is MP86945AGLT used for on a laptop motherboard?
MP86945AGLT by Monolithic Power Systems (MPS) is a MOSFETs de Potência e DrMOS integrated circuit in a TQFN (5x5mm / 4x5mm) package (input voltage 4.5V – 22V; output/spec: 60A Intelli-Phase DrMOS Stage). MPS 60A Intelli-Phase DrMOS Power Stage for High-End Gaming Laptop CPU/GPU Vcore
What is the SMD marking code for MP86945AGLT?
The top silkscreen SMD marking code for MP86945AGLT is MP86945, 86945A (trailing characters on the package represent factory date/lot codes). Known pin-compatible equivalents: MP86945AGLT.
What are the key diagnostic pins / startup conditions of MP86945AGLT?
Key multimeter diagnostic pin measurements for MP86945AGLT: Pin VIN (VIN): High-voltage input from B+ (CRITICAL: check VIN-to-SW short before powering!); Pin VCC/PVCC (VCC/PVCC): +5V internal gate driver supply; Pin PWM (PWM): Tri-state PWM input from multiphase controller (Hi-Z = Hi/Lo FETs off); Pin EN/DISB# (EN/FCCM): Driver enable / CCM mode control; Pin BOOT (BOOT): Bootstrap capacitor pin to SW.
Which laptop motherboards use MP86945AGLT (donor boards)?
Use the SchemCAD interactive workbench or @BoardSchemBot to locate MP86945AGLT across 39,000+ laptop schematics and BoardView layouts.